Free VMware 3V0-25.25 Exam Practice Questions

An administrator is configuring Border Gateway Protocol (BGP) routing on a Tier-0 Gateway to optimize north---south traffic flow between the NSX environment and multiple upstream physical routers. The environment includes two external connections that advertise overlapping routes to the same destination networks. To ensure predictable and efficient routing behavior, the administrator decides to manipulate specific BGP attributes on outbound advertisements and inbound route updates. What are two valid BGP Attributes that can be used to influence the route path traffic will take? (Choose two.)

An administrator is troubleshooting an issue where workloads connected to a Tier-1 Gateway named T1-App can no longer reach external North/South destinations.

* The Tier-1 is connected to an Active/Standby Tier-0 Gateway named T0-Prod.

Symptoms observed:

* VMs on segments attached to T1-App can ping each other.

* VMs on T1-App cannot reach any external IP outside T0-Prod.

* From a VM on the segment, ping to the T1-App Distributed Router (DR) IP succeeds.

* Ping from the VM to the T1-App Service Router (SR) fails.

* The Edge cluster hosting the T1-App SR shows both Edge nodes Up and Healthy.

* No failover has occurred --- the same Edge node is still shown as Active for T1-App.

What is the most likely cause of this issue?

An administrator has noticed an issue in a freshly deployed VMware Cloud Foundation (VCF) environment where the BGP neighborship between the Tier-0 gateway and a physical router remains in the Idle state. Pings between the uplink IPs are successful. What is the issue?

An administrator is preparing to deploy a new workload domain that will host vSphere Kubernetes Service (VKS) clusters. Before configuring the network for the Kubernetes clusters, the administrator needs to create a Tier-0 Gateway to handle North/South connectivity. What is the requirement for creating a Tier-0 Gateway for use with a workload domain that is running the vSphere Kubernetes service (VKS) with VPC?

An administrator is tasked to enable users to configure an individual VPC, but not create subnets. What three NSX roles would the administrator assign to allow access without the ability to create subnets? (Choose three.)